The new wireless LT-55 XL functions the same way as the previous model while templating. However to start the laser up there is a little different method. Follow the steps below and you should have no problem.

  1. When you walk into the job site, turn the Tablet PC on.Ensure the Bluetooth dongle is inserted into the side USB port on the ASUS Tablet PC.
  2. Set up the tripod while Windows is starting on the Tablet PC.
  3. Place the LT-55 XL laser on the tripod.
  4. Plug in the USB cable into the Tablet PC after Windows has fully started.
  5. DO NOT OPEN THE LT-55 XL PROGRAM YET.
  6. Once you hear a kerplunk sound indicating the USB cable was connected, press the power button on the side of the laser.
  7. After the laser shows a green light on the side next to Power then start the LT-55 XL application by double clicking on LT-55 XL on the desktop.
  8. You will see in the top bar “LT Connected on COM# & COM#”
  9. If the top bar shows “LT Disconnected”
  10. Exit the LT-55 XL application.
  11. Unplug the USB cable and plug it back in so that you hear the kerplunk sound signaling the USB cable was connected.
  12. Make sure the laser is on indicated by the green light on the side of the laser next to Power.
  13. Start the LT-55 XL application by double clicking on LT-55 XL on the desktop.
  14. After connected, press Laser On and you can begin templating.
Tagged: