VisioForge Drivers & DLLs

Issue: You receive the following error when attempting to Add Photos to a job. Could not load file or assembly ‘VisioForge.Controls.WinForms, Version=7.2.0.1, Culture=neutral, PublicKeyToken=e987dad4f52b3894′ or one of its dependencies. An attempt was made to load a program with an incorrect format. Cause: The wrong VisioForge drivers and/or DLLs are installed on the tablet causing the […]

Read More

Unknown USB (Device Decriptor Request Failed)

Issue When you plug in the USB cable from the LT-2D3D/LT-55 XL a notification bubble appears in the lower right corner of the screen. Unknown USB Device (Device Descriptor Request Failed) Cause The driver that is used to allow the encoder (how the laser measures angles) has been either updated to an incorrect Microsoft Driver. […]

Read More

Acer w510 Lock-up issue

Issue: The Acer w510 Iconia tablet will randomly lock-up while templating. Cause: This is actually not an issue with the LT-55 XL software. It is instead an issue with some of the drivers that came shipped with the Acer w510 Iconia tablet. Drivers are what allow software to communicate with hardware. Since Acer has updated […]

Read More

Bluetooth Driver

We have a new updated Bluetooth driver for the Wireless LT-55 XL’s. You can download it and run it from your desktop. You can download it from the following address. http://laserproductsus.com/dlfiles/LT55installfiles/lt55wireless/SetupBtwDownloadSE.exe

Read More

Install CDM (USB) Driver

The CDM (USB) Driver allows the Tablet PC to communicate with the Laser/Encoder via USB. This is installed on every Tablet PC before it is shipped however if the Tablet PC does recognize the laser is connected but it will not connect through the LT-2D3D/LT-55 XL software, re-installation of the CDM Driver corrects the problem. […]

Read More